How to install Sure Edge Drip Trim
-
The ClassicBond One Piece EPDM system is great for large or small flat roof areas and is normally bonded on to a timber deck in one piece so no joins!
Find out more! -
The RESITRIX Reinforced Self-Adhesive system is perfect for complicated flat roofs, gutter linings, parapet walls and awkward shapes. Also the right choice for overlaying most existing roofing coverings.
Find out more!
Step by Step Installation Guide
-
Install the Gutter Trim Back Plate
Install the Sure Edge Gutter Trim Back Plate onto a 50mm by 25mm timber baton along at the gutter edge.
-
Attach with the Nails Provided
Use the stainless steel ring shank nails provided. Allow an expansion gap of 1 mm per metre of run between lengths of Sure Edge PVC trim
-
Fix the Sure Edge PVC Trims into Position
When the membrane installation is complete the Sure Edge PVC trims can be fixed into position. These finish the roof neatly and provide additional securement for the membrane at the roof perimeter
-
Attach the Sure Edge Gutter Trim Front Plate
The Sure Edge gutter trim front plate is nailed into position using the supplied Poly Top nails through the pre drilled fixing holes. This provides the installer with preset centres for the fixings and ensures the gutter Edge is fixed securely and neatly. The pre-applied foam strip forms a water tight seal under compression and enSures water flows over the top of the trim
-
Trim of the excess membrane
Trim off the excess membrane from the Gutter Edge
-
Staple the Membrane
If stapling the membrane at the corners, ensure the staples are always weathered prior to installing the Sure Edge check kerb
-
The End!
Well done - you've installed your Sure Edge Drip Trim!