ClassicBond® One Piece EPDM Rubber Roof Covering 1.20mm

Yes all of our EPDM membranes can be joined where the roof is bigger than the largest membrane size or where it would be easier to install the membrane in smaller sections.

Yes you can install EPDM under a pitched tiled roof. This may be necessary on shallow pitched roofs to prevent leaks.

Yes to an extent. EPDM is designed to take LIGHT foot traffic during installation and for occasional cleaning or maintenance. If you require more use than this, i.e. for a balcony then there are additional materials that can be laid over your EPDM for a more durable solution.

You will typically need a standard 9" roller set, mini roller and brush for applying the adhesives and primers. A Seam Roller is a useful tool for tapes and joins and the RESITRIX system will require a heat gun for joins.

Yes, EPDM Membranes require the substrate to be dry prior to installation. This is so the the adhesive & primers can effectively bond the rubber to roof deck. EPDM products will not adhere to wet or damp surfaces. Trapped moisture may vaporize and negatively affect the performance of the membranes.

ClassicBond and ShedCover = 1.2mm or 1.5mm RESITRIX = 2.5mm DuoPly = 2.54mm ClassicLiquid = 1.2mm in one coat

If the pitch of your roof is too shallow for roof tiles and installing an EPDM rubber membrane can be an excellent solution to this problem

Yes, ClassicBond membrane holds the British Board of Agrément certificate, No. 11/4853 (issued to Flex-R Ltd). It also holds fire ratings for each of the thicknesses available.

No The ClassicBond EPDM membrane is only available in a slate grey colour,

Classicbond EPDM membranes are identical on both sides so there is no right or wrong side when installing. However you may sometimes find a small amount of writing printed on one side of the Rubber Membrane and it may be wise to keep this side down so an eyesore is not created.

CLASSICBOND® EPDM is CE marked with a nominal thickness of 1.2mm as opposed to the thinner 1.1mm of Firestone RubberCover as defined by EN 13956

The biggest sheet size available in each system is as follows, all sheets can be joined where the roof size is bigger than the maximum sheet size: ClassicBond & Shedcover 1.2mm - 15.25m x 30.5m (50ft x 100ft) ClassicBond & Shedcover 1.5mm - 15.25m x 15.25m (50ft x 50ft) DuoPly 2.54mm - 1.52m x 12.20m (5ft x 40ft) RESITRIX 2.50mm - 1M x 10M (3ft 4" x 32ft 10")

The first commercial rubber roof was installed in the United States in 1965 by Carlisle Syntec, it is now 50 years old and still going strong. This makes ClassicBond the only EPDM with a proven 50 year life expectancy!

Whilst bubbles or blisters on a once-piece EPDM roof can be unsightly they will not cause the rubber membrane to fail. These bubbles of trapped air/moisture can be caused by a variety of issues which are all avoidable if the roof design is correct and the membrane correctly installed.