Pipe Boot (25mm to 150mm)

Used For: EPDM pipe boots are used to create a waterproof seal between the roof deck and protruding pipework.

Diameter: 25 - 150 mm Diameter

Material: EPDM Rubber with steel adjustable hose clip

Installation Notes:
1) After installing the roofing membrane place the pipe boot in position by sliding it over the drain or pipe. You may need to cut to required diameter
2) Mark the roofing membrane to show where rubber primer is to be applied
3) Remove boot and apply rubber primer
4) Wait until primer is touch dry and then re-install the pipe boot positioning over the pipe and onto the roof membrane.
5) Smooth down the join with a seam roller
6) Roll back the top of the boot and apply water cut off mastic around the pipe.
7) Roll back top of boot over mastic and install and tighten hose clip using screw driver.

This Article is suitable for the following EPDM products

You might also need these products for your job...

Professional Seam Roller£24.60Professional Seam Roller
Rubber Primer£5.00Rubber Primer
Water Cut off Mastic£6.50Water Cut off Mastic

Pipe Boot (25mm to 150mm)

This Article is suitable for the following EPDM products

You might also need these products for your job...

Buy Now