Call: 0800 313 4486

Basket: 0 Items £0.00   |   Trade Login

Contact Adhesive

Home » Adhesives and Sealants » Contact Adhesive

Used For: Adheres rubber roofing membrane to most materials. Used on up-stands and vertical surfaces or old Felt

Size: 1.0 Litres (Coverage 1 to 2 sqm)
Size: 2.5 Litres (Coverage 4 to 6 sqm)
Size: 5.0 Litres (Coverage 7 to 10 sqm)
Size: 10 Litres (Coverage 15 to 20 sqm)

Coverage: 0.6 Ltr / m2 when applied to both sides (depending on surfaces)

Colour: Opaque yellow

Application Up-stands: Use a 4" mini roller to apply contact adhesive to both the up-stand and rubber roofing membrane. It is also good practice to secure the membrane to the deck perimeter with a 150mm width strip of contact adhesive. This will stop the membrane from lifting due to shrinkage. Ensure that the contact adhesive is touch dry before rolling the membrane onto the substrate/up-stand.

Application Non-Permeable Deck: Using a sheepskin roller apply contact adhesive to both the deck and underside of membrane evenly. Ensure that the contact adhesive is touch dry before rolling the membrane onto the deck. Note It is not possible to re-position the membrane once stuck down using contact adhesive.

Installation Tip: Allow approximately 5-20 minutes for the contact adhesive to become touch dry dependant on weather conditions. If the membrane is bonded whilst the contact adhesive is still wet you may notice air bubbles appearing under the membrane. These will disappear within a short period of time due to the rubber roofing membrane being partially breathable.

You might also need these products for your job...

• 100mm Min Roller With Two Sleeves£2.50100mm Min Roller With Two Sleeves

Buy Now